OEM manufacturer Roller Mill For Gold - Mechanical Machine Pump Spares Pump Casing – Special Metal Detail:
The pump casing we offer can meet the followings:
1. Tolerance size of the casting shall conform to ISO8026-3 DCTG 13-RMA 6(RMAG H)-GCTG 7-DS
2. Cracks, burnt, sand and slag inclusions are not allowed. On the unhandled surfaces should not be defects reducing the strength, performance and degrade casting presentation. Allowed correction of welding, in which defective cutting may be performed by the manufacturer’s instruction. Locations of these defects in the casting and the butchering size under welding must be registered and entered in the casting documents. After removal of butchering defects, the surface should be grinded and monitored for completeness remove defects by dye penetration
3. Carry out UT of the castings: the end surfaces along the entire length in the area of the flange connector of the pump housing and cover (zone 1) in the area of the suction flange connector (zone2),in the area of the discharge flange connector (zone3), permitted without correcting defects of the equivalent size to 5mm not more than 3pcs.
4. The conformity checking with the chemical composition of the steels should be carried out from the each melt.
Our main material for cast iron pump cases is similar to followings:
Standard Specifications for Cast Iron |
||
Country |
Standard |
Grade |
China | GB 9439 | HT150,HT200 |
United Kingdom | BS 1452 | Grade150 |
USA | ASTM A 48 | 20B |
ASTM A159 | G1800 | |
Germany | DIN 1691 | GG15, GG20 |
Europe | EN1563 | GJL150,GJL200 |
Japan | JIS G5501 | FC150,FC200 |
International | ISO 185 | 150,200 |
5. The steel mechanical properties: Tensile strength not less 441MPa, elongation Q not less 19%, impact strength not less 392KJ/m2, hardness HB 121-151. The mechanical properties of the steel are necessary to control for each melt. Test results apply to all the castings from this melt, heat-treated in the same mode, record by automatic devices.
Production Process
1. Wooden pattern Production
2. Molding
3. Pouring
4. First cleaning
5. Heat treatment – grinding (inspection)
6. Rough machining (inspection)-finishing machining (inspection)
7. Packing-delivering
Quality assurance
The fabrication route is governed by the provisions of the implemented Quality System ISO 9001: 2000. The standard documentation ensures the full traceability of every process step:
• Manufacturer test certificates according to DIN EN 10.204 § 3.1 including chemical composition, mechanical properties and non-destructive examination;
• Dimensional check supported with a “as-built“ sketch;
• Record of the heat treatment chart
Product detail pictures:
Related Product Guide:
Assessing Dell EMC’s aggressive channel plans | Lead Ingot Mold
‘Eoka fighters delivered an independent and sovereign state’ (Update 2- adds Akinci comments) | Cast Steel Nodes
With our leading technology also as our spirit of innovation,mutual cooperation, benefits and development, we are going to build a prosperous future jointly with your esteemed company for OEM manufacturer Roller Mill For Gold - Mechanical Machine Pump Spares Pump Casing – Special Metal, The product will supply to all over the world, such as: Iraq , Madras , Iran , The company has perfect management system and after-sales service system. We devote ourselves to building a pioneer in the filter industry. Our factory is willing to cooperate with different customers domestic and overseas to gain better and better future.
By Rae from Turkey - 2016.12.31 14:53
Good quality and fast delivery, it's very nice. Some products have a little bit problem, but the supplier replaced timely, overall, we are satisfied.
By Lauren from Curacao - 2016.09.26 12:12